On-chip voltage-controlled oscillator based on a center-tapped switched inductor using gan-on-sic hemt technology

Hsuan Ling Kao*

*Corresponding author for this work

Research output: Contribution to journalJournal Article peer-review

Abstract

This study presents a voltage-controlled oscillator (VCO) in a cross-coupled pair config-uration using a multi-tapped switched inductor with two switch-loaded transformers in 0.5 µm GaN technology. Two switch-loaded transformers are placed at the inner and outer portions of the multi-tapped inductor. All the switches are turned off to obtain the lowest sub-band. The outer transformer with three pairs of switches is turned on alternately to provide three sub-band modes. A pair of switches at the inner transformer provide a high-frequency band. Two switch-loaded transformers are turned on to provide the highest sub-band. Six modes are selected to provide a wide tuning range. The frequency tuning range (FTR) of the VCO is 27.8% from 3.81 GHz to 8.04 GHz with a varactor voltage from 13 V to 22 V. At a 1 MHz frequency offset from the carrier frequency of 4.27 GHz, the peak phase noise is −119.17 dBc/Hz. At a power supply of 12 V, the output power of the carrier at 4.27 GHz is 20.9 dBm. The figure of merit is −186.93 dB because the VCO exhibits a high output power, low phase noise, and wide FTR. To the best of the author’s knowledge, the FTR in VCOs made of GaN-based high electron mobility transistors is the widest reported thus far.

Original languageEnglish
Article number2928
JournalElectronics (Switzerland)
Volume10
Issue number23
DOIs
StatePublished - 01 12 2021

Bibliographical note

Publisher Copyright:
© 2021 by the author. Licensee MDPI, Basel, Switzerland.

Keywords

  • Frequency tuning range
  • GaN-on-SiC
  • Voltage-controlled oscillator

Fingerprint

Dive into the research topics of 'On-chip voltage-controlled oscillator based on a center-tapped switched inductor using gan-on-sic hemt technology'. Together they form a unique fingerprint.

Cite this