跳至主導覽 跳至搜尋 跳過主要內容

Influence of applied load on vacuum wafer bonding at low temperature

  • Wei Bo Yu*
  • , Cher Ming Tan
  • , Jun Wei
  • , Shu Sheng Deng
  • , Sharon Mui Ling Nai
  • *此作品的通信作者
  • Nanyang Technological University
  • Agency for Science, Technology and Research, Singapore

研究成果: 期刊稿件 › 文章 › 同儕審查

18 引文 斯高帕斯(Scopus)

摘要

Low temperature direct wafer bonding was performed in medium vacuum (∼10-4mbar). Different loads were applied during bonding processes. In all cases, the bond strength is above 19MPa, which is high enough for practical applications. More interestingly, in contrast to the findings by others, we found that the applied load does play a very important role in wafer bonding, the higher the applied load, the lower the bond strength. In the case of zero applied load, the cracking during pull test occurred in the silicon wafer itself rather than at the bonding interface. The bonded wafers were examined by means of scanning acoustic microscope (SAM). It was found that both the bubble size and bubble number increase with an increase in applied load. This phenomenon is contributed to the applied load. High applied load keeps two wafer surfaces in tight contact. If there are any impurities trapped during bonding process, such as air and water molecules, the tight contact prevents them from escaping out of the bonding interfaces, which results in the low bond strength. The distinctness between results from other works and our experiment were explained from the different dominant mechanisms in different wafer bonding processes.

原文英語
頁(從 - 到)67-72
頁數6
期刊Sensors and Actuators, A: Physical
卷115
發行號1
DOIs
出版品狀態已出版 - 15 09 2004
對外發佈是

指紋

深入研究「Influence of applied load on vacuum wafer bonding at low temperature」主題。共同形成了獨特的指紋。

引用此